Broadcom bcm4360 802.11 wireless controller 6.37.14.126 (r561982)

BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) INSTALL
BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) DRIVERS
BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) DRIVER
BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) LICENSE
BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) BLUETOOTH

Modules linked in: snd_hda_codec_generic(+) ledtrig_audio rapl wl(POE+) intel_cstate snd_hda_intel snd_intel_dspcfg snd_hda_codec snd_hda_core snd_hwdep snd_pcm btusb btrtl btbcm btintel lpc_ich bluetooth i915(+) snd_seq_midi ecdh_generic ecc snd_seq_midi_event snd_rawmidi snd_seq input_leds drm_kms_helper cfg80211(OE) bcm5974 snd_seq_device snd_timer drm bdc_pci compat(OE) snd i2c_algo_bit fb_sys_fops syscopyarea sysfillrect mei_me sysimgblt dw_dmac_pci mei soundcore sbs applespi spi_pxa2xx_platform sbshc dw_dmac dw_dmac_core acpi_als kfifo_buf apple_bl industrialio mac_hid sch_fq_codel parport_pc ppdev lp parport ip_tables x_tables autofs4 hid_apple hid_generic usbhid hid uas usb_storage ahci thunderbolt libahci video

BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) LICENSE

wl: module license 'MIXED/Proprietary' taints kernel. I have also entered etc/modprobe.d/nf and commented out the section bcm43XX

BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) INSTALL

sudo apt-get install -reinstall bcmwl-kernel-source Namely I have made sure the appropriate modules are installed. I have followed the the top answer at this link. Memory at b0400000 (64-bit, non-prefetchable) Memory at b0600000 (64-bit, non-prefetchable) BCM4360 802.11ac Wireless Network AdapterДЇlags: bus master, fast devsel, latency 0, IRQ 18 and subsidiaries BCM4360 802.11ac Wireless Network Adapter (rev 03) Network Controller Info:Д 3:00.0 Network controller: Broadcom Inc. This is due to problems surrounding my network controller. Just make sure to properly remove or disable any 'fix' that didnt work before trying something else.Hello I am using Ubuntu 18.04 and am unable to connect to the wifi. Hopefully it can set you on the right path. downgrading kernel works if your card is BCM4360)

Stability is an issue for some, look at Broadcom wireless for possible fixes (e.g. If built against the wrong kernel you may encounter an errorДЄnd then under 'what doesnt work' there was this for wifi :Д«roadcom-wl or broadcom-wl-dkms from the AUR works

Note that it does have to be built against the exact same kernel version as used by the installer, and this may differ from the latest version. For custom kernels, you need to use broadcom-wl-dkms. Install b43-firmware, b43-firmware-classic or b43-firmware-legacy from the AUR.Д«ut then for that specific card/macbooks there was also this on arch wiki.Д«roadcom-wl is sufficient if you are using the Linux mainline kernel.

BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) DRIVERS

To avoid erroneous detection of your WiFi card's chipset, blacklist the unused driver.Д«oth of these drivers require non-free firmware to function.

BROADCOM BCM4360 802.11 WIRELESS CONTROLLER 6.37.14.126 (R561982) DRIVER

Two reverse-engineered open-source drivers are built-in to the kernel: b43 and b43legacy.Д«43 supports most newer Broadcom chipsets, while the b43legacy driver only supports the early BCM4301 and BCM4306 rev.2 chipsets.

I'm tired installing the b43 drivers but it didn't work. Device Flags: bus master, fast devsel, latency 0, IRQ 18 Memory at c1200000 (64-bit, non-prefetchable) Memory at c1000000 (64-bit, non-prefetchable) Capabilities: Kernel driver in use: bcma-pci-bridge Kernel modules: bcma Lspci -vnn -d 14e4: displays the followingД 3:00.0 Network controller : Broadcom Corporation BCM4360 802.11ac Wireless Network Adapter (rev 03) Subsystem: Apple Inc. ip link:ДЎ: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 2: ens9: mtu 1500 qdisc mq state UP mode DEFAULT group default qlen 1000 link/ether 38:c9:86:39:03:16 brd ff:ff:ff:ff:ff:ff Ip link only shows my ethernet connection. Its a shame because everything works flawlessly on my thinkpad. the computer being used is a macbook air 7,1. It is not scanning, only displaying 'No networks available'. After a fresh install of manjaro I noticed my wifi is not working.

Broadcom bcm4360 802.11 wireless controller 6.37.14.126 (r561982)